Asia Pacific and Oceania. This is a shot in the dark but, a relative has the same exact computer as mine. Track this discussion and email me when there are updates. Asia Pacific and Oceania. If your system has only one SATA hard drive, you must connect the hard drive data cable to the dark blue connector labeled SATA0 to avoid any hard drive performance problems.

Uploader: Dagore
Date Added: 16 December 2016
File Size: 26.44 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 27288
Price: Free* [*Free Regsitration Required]

When replacing the battery, use a battery equivalent to the battery originally installed in the computer.

Back to PC Hardware forum 9 total posts. A pin connector, as well as a separate post, secures the ReadyBoost card to the system board. The security screw is located on the fan duct inside the chassis. If you are installing a primary hard drive, use the power connector labeled P4. Before removing the computer access panel, ensure that the computer is turned off and that the power cord is disconnected from the electrical outlet.

If you are adding a second hard drive, connect the data cable to the next available unpopulated SATA connector on the system board in the following order: Disconnect all cables connected to the system board, noting their location for reinstallation.

PCI Express x1 expansion slot. If you are not installing a new expansion card, install an expansion slot cover to close the open slot. After installing a new processor onto the system board, always update the system ROM devicee ensure that the latest version of the BIOS is being used on the computer.

  DELL POWEREDGE T100 VIDEO DRIVER DOWNLOAD

When installing an expansion card, press firmly on the card so that the whole connector seats properly in the expansion card slot. Never crease or bend a SATA data cable tighter than a 30 mm 1.

Heatsink retaining screws should be removed in diagonally opposite pairs as in an X to even the downward forces on the processor. Sharp creases may damage the wires. Cable Connections System board connectors are color-coded to make it easier to find the proper connection.

HP Customer Support – Software and Driver Downloads

If installing a new drive, connect the opposite end of the data cable to the appropriate system board connector. You are posting a reply to: Lift up on the tab at the top of the lock and rotate the lock open. It is software which finds, downloads and istalls the correct driver for you – automatically. Why cant there be just a fc5850 easy fix??

Drives When installing additional drives, follow these guidelines:. Scoreboard Ratings See detailed Compaq customer service rankings, employee comments and much more from our sister site. Use tweezers or a small needle-nose pliers to compress the locking tip on the plastic standoff that secures the ReadyBoost module and then carefully lift the back edge of the module until it releases. Static electricity can damage the electronic components of the computer or optional equipment.

  LANIER 620C DRIVER

What was on the ISA bus were items like serial and parallel ports. Compaq Presario CQ60 Driver. When the battery is removed or replaced, the CMOS settings will be cleared.

See your browser’s documentation for specific instructions. Do NOT handle the pins in the processor socket. If you are removing a diskette drive, disconnect the data cable 1 revice power cable 2 from the back of the drive.

Removing an External 5.

Unknown Device: PCI Standard ISA Bridge – Forums – CNET

A sharp bend can break the internal wires. Track this discussion and email me when there are updates. No software or drivers are available for this product with the selected operating system. If you are installing an optical drive, connect the power cable 1 and data cable 2 to the back of the drive.